Condition Monitoring
A node on the machine shows whether it is running and when it took a knock, with alerts on the limits you set and the readings on the asset in your Unreal twin.
You check the compressor every second Thursday because the schedule says so. Between visits nobody knows whether it ran all weekend or took a knock on Tuesday, so each visit either finds nothing or finds the problem late.
How Twinise Solves This
A node on the housing reports movement through its IMU, and the air temperature and humidity beside it. Twinise stores one reading per device per minute and holds your alert rules. In the Unreal twin (pilot) the readings sit on the machine itself.
What You Get
- Running or stopped. The IMU tells a running machine from a stopped one, and how roughly it runs. Put a threshold on it and a knock between visits raises an alert instead of going unrecorded.
- The air around the asset. Temperature and humidity next to motors, panels and plant. The nodes read the air beside the equipment, not its surface.
- Rest-state rules. Run Calibrate while the machine is stopped and an alarm rule can follow that rest state, so the limit comes from the machine and not from a guess.
- Alerts with a trail. One active alert per rule, kept open until someone acknowledges it and resolves it in the portal.
- On the machine in the twin. In the Unreal plugin (pilot), mesh tint, material parameters and heatmaps put the reading on the asset.
Recommended Hardware
The Starter Kit is 8 nodes, enough for a plant room or a single line. Larger deployments use the same nodes and are scoped with you. Hardware is currently supplied as a pilot, by arrangement. Vibration sensing is tested on our nodes rather than stocked in a kit. Tell us the asset and we can integrate it.
Where To Start
Begin with the assets on your walk-round list. Mount a node on each, run Calibrate while the machine is stopped, and set the alarm to follow that rest state. A few weeks of history, within your plan's window, will show which machines earn their visits.
Want to try this on your own site?
Hardware is supplied as a pilot, by arrangement. Tell us about your site and we will scope condition monitoring with you.
Request a pilot